Pages

Thursday 31 March 2011

Terrain is everything - 40k Hex tower 2.

Here's one of my oft delayed terrain pieces. You can probably tell reading through it that there was a lot of improvisation going on and as the piece developed ideas about how to make this even more versatile cropped up, hence the delay because I never got round to creating the STC. I'll get there in the end don't worry but meanwhile you'll just have to enjoy the process and the inspiration.

After I made the 40k outpost, that got bigger and it's attendant tower the next addition to my scenery collection [way back when] was inspired by 'found materials. We get large scale plotter paper at work and these rolls have plastic endcaps as shown below



So I wanted to build a platform based around this end cap, here's the sketch:


A hexagonal base was made and stuck to a CD [no warping card this time]


Then, foamcard was used for the walls and granny grating for the base. A hole was cut in the centre to allow a lift to come up from the base [still to do]


In the process I realised if I split one of the walls I can create walkways to connect more of these babies together. Here's the removable section

 

I have some different sized end caps which will add some variety and I may add some variety in height so I could potentially stack some of the platforms [if they come without CD bases]. Alternatively the hex tower can fit in the centre, but it'd look kind of odd.

I've still to prepare the walkways but I will be using foamcard and granny grating for the base of those and walls with the same pattern.
Here's the slightly smaller one


A view from above which shows that the smaller printer end cap is not closed, so you get a nice see-thru effect through the granny grating.


A possible layout using the removable wall plates. Still need to complete some walkways but it's quite versatile already, although probably too much for my small table.


Here's a figures eye view showing the completed doors.


Quite a lot of pics there, so I'll post the painted ones another time. As I mentioned before the STCs for these are still in development. I wanted to add an internal hexagonal column that would be the same height as the corner pieces. This would allow the stacking of the platforms. Additionally I have the advantage of the printer end caps, providing extra bits for you to make your own floorplate within the template is another thing to consider. I'll get there though.

No comments:

Post a Comment